Section Contents

EN 16733:2015

Reaction to fire tests for building products – Determination of a building product’s propensity to undergo continuous smoldering

This standard specifies a test method to determine the ability of a building product to smoulder continuously when tested in a vertical orientation and when exposed to an open flame under the influence of natural convection airflow. The method does not impose any mechanical influence to the airflow since this would not be representative of most end-use conditions.

The test specimen is vertically mounted and has its surface exposed to a flame providing a constant heat from a propane gas burner. Smouldering is detected by measuring temperatures using thermocouples installed at defined distances within the vertical test specimen and the observation of sustained flaming following re-ignition.

The standard is intended for all building products classified according to EN 13501-1 and will, therefore, eventually affect wood-based products covered by the harmonised European standard EN 13986 when this standard is revised.

 

 

APA in Europe Wizard

Close
All Questions OSBPlywood

What is a ‘life cycle stage’ and how do these link to the environmental assessment of whole buildings?

How do core category rules link with environmental product declarations?

Whose responsibility is it to check that wood products being imported into the EU do not originate from illegally sourced timber supplies?

Does the EUTR require mills to provide any extra documentation for customs entry into the European Union?

Must all plywood and OSB panels carry a CE marking?

What is the definition of a construction product under the CPR?

What is a Declaration of Performance referred to under the Construction Products Regulation?

What is the difference between Structural 1 and Exposure 1?

Does structural panel siding have shear values?

What are mould and mildew, and do they compromise the integrity of engineered wood?

The CE-mark on an APA plywood panel means it conforms to European Standards – but which ones?

I want to use a Rated Sheathing panel for flooring/ roofing application, what info do I need to know?

Plywood: Span rating
OSB: Span rating

What extra strength benefits do Structural 1 OSB panels provide over standard Rated Sheathing panels?

Do APA panels give off formaldehyde?

Plywood: Formaldehyde
OSB: Formaldehyde

What is the difference between a touch-sanded panel and sanded panel?

I’d like to know how APA veneer grades match those given in the European standards

How do I correctly gauge the face appearance a plywood Siding panel?

I want to specify an APA panel for concrete formwork – what do I need to know?

Are APA panels tongue and grooved on all four edges?

I am not familiar with the term ‘Sized for Spacing’ – what is its significance?

How are Performance Category and thickness related?

I’d like to know more about a panel’s Span Rating and how it links to thickness.

Plywood: Span rating
OSB: Span rating

What is Span Rating on the APA trademark and why is it important?

Plywood: Span rating
OSB: Span rating

What is the difference between Exposure 1 and Exterior plywood panels? What are their appropriate uses?

What are the main OSB panels likely to be available in Europe?

What are the main plywood panels likely to be available in Europe?

What are the main European standards that I would need to be aware of for OSB panels?

The main standards are: EN 13986 and EN 300

What are the main European standards that I would need to be aware of for plywood panels?

The main standards are: EN 13986, EN 636, EN 314, EN 635-3